3D Bioplotter Research Papers

Displaying all papers about Myoblasts (4 results)

Characterization of Cell Damage and Proliferative Ability during and after Bioprinting

ACS Biomaterials Science & Engineering 2018 Volume 4, Issue 11, Pages 3906–3918

When a biomaterial solution containing living cells is subject to bioprinting, the cells experience process-induced stresses, including shear and extensional stresses. These process-induced stresses breach cell membranes and can lead to cell damage, thus reducing cell viability and functioning within the printed constructs. Studies have been conducted to determine the influence of shear stress on cell damage; however, the effect of extensional stress has been typically ignored in the literature until the recently collected evidence of its importance. This paper presents a novel method to characterize and quantify the cell damage caused by both shear and extensional stresses in bioprinting….

Rheological, In Situ Printability and Cell Viability Analysis of Hydrogels for Muscle Tissue Regeneration

Proceedings of the 29th Annual International Solid Freeform Fabrication Symposium – An Additive Manufacturing Conference 2018 Pages 835-846

Advancements in additive manufacturing have made it possible to fabricate biologically relevant architectures from a wide variety of materials. Hydrogels have garnered increased attention for the fabrication of muscle tissue engineering constructs due to their resemblance to living tissue and ability to function as cell carriers. However, there is a lack of systematic approaches to screen bioinks based on their inherent properties, such as rheology, printability and cell viability. Furthermore, this study takes the critical first-step for connecting in-process sensor data with construct quality by studying the influence of printing parameters. Alginate-chitosan hydrogels were synthesized and subjected to a systematic…

Construction of 3D biological matrices using rapid prototyping technology

Rapid Prototyping Journal 2009 Volume 15, Issue 3, Pages 204 - 210

Purpose Hydrogels with low viscosities tend to be difficult to use in constructing tissue engineering (TE) scaffolds used to replace or restore damaged tissue, due to the length of time it takes for final gelation to take place resulting in the scaffolds collapsing due to their mechanical instability. However, recent advances in rapid prototyping have allowed for a new technology called bioplotting to be developed, which aims to circumvent these inherent problems. This paper aims to present details of the process. Design/methodology/approach The paper demonstrates how by using the bioplotting technique complex 3D geometrical scaffolds with accurate feature sizes and…

Formed 3D Bio-Scaffolds via Rapid Prototyping Technology

IFMBE Proceedings 2009 Volume 22, Pages 2200-2204

The construction of biomaterial scaffolds for cell seeding is now seen as the most common approach for producing artificial tissue as compared with cell self-assembly and Acellular matrix techniques. This paper describes the use of synthetic and natural polymeric material shaped into 3D biological matrices by using Rapid Prototyping (RP) technology. Recent advances in RP technology have greatly enhanced the range of biomaterials that can now be constructed into scaffolds, also allowing for maximized control of the pore size and architecture. Bioplotting is one such method which allows the dispensing of various biomaterials into a media bath which has similar…